View Single Post
  #5  
Old 02-28-2020, 03:09 PM
Russell S. Russell S. is offline
Senior Member
 
Join Date: Jun 2015
Posts: 251
Default Re: 2 Gallon Pot Tilt Ring Size?

I have one that did the same thing. The whole area is too thin and fragile to weld. I tried drilling and tapping it but the hole just kept growing. I started with 8/32”and gave up after 3/8” so thin it wouldn’t hold a bolt. I have a couple of pieces that I did drill and tap out to 10/24” and installed a stainless screw and ground it off on the inside and left the head on the outside. But the metal on those was thick enough and held up to the drilling and tapping. Mine sits by my fireplace.
Reply With Quote