Cast Iron Collector Forums  

Go Back   Cast Iron Collector Forums > General Discussion > New Collector's Corner


New Collector's Corner A Friendly Forum for Those New to the Hobby. No Question Is Too Basic, So Ask Away.

Thread Tools Display Modes
Old 12-18-2017, 10:31 PM
D_Madden D_Madden is offline
Senior Member
Join Date: Dec 2016
Location: Southern Indiana
Posts: 941
Default Iron Pricing

I stopped at a little antique/consignment shop that I've found iron at before. It's about an hour away but I was in the area for other reasons. One booth had a stack of skillets... after going through them all most were asian, and rusty... there was a single notch lodge #7 with a raised 7 on the top of the handle, but the bottom was very pitted. There was another booth that had a locked glass case with a #0 griswold in it and one of the little tea size corn stick pans (both were marked at $94!) Then I found one booth that had 8 - 10 pieces of iron on a small shelf in the back of the booth. On the top shelf were a couple of corn stick pans, a griswold bread stick pan (no 22)... so they got my attention... good condition, not cleaned up but in decent shape... the bread stick pan was marked $70 and the griswold corn stick pan was marked $45... I almost stopped looking at the rest... noticed a couple of skillets on the bottom shelf and thought it would be good for a laugh to see what they had those priced at. smooth bottom large block logo #8 marked at $32 (fairly clean and flat) and the other one was a heat ring slant/erie #5 marked at $38. I have no idea where this guy was getting his prices from... anyway the #5 came home with me. (it will look good with my 3 and 4 slant eries.)
Reply With Quote
Old 12-19-2017, 10:57 AM
SpurgeonH SpurgeonH is offline
Senior Member
Join Date: Aug 2016
Location: Marietta, GA
Posts: 1,046
Default Re: Iron Pricing

Some of the prices at antique stores amaze me. I've seen overpriced pieces, in stores I regularly stop in, that have been there for two years! Why not mark them down and generate some cash flow? Maybe they figure someday a guy will come along who needs that one piece to round out a collection and they will finally get their price. Ha!

And then you have the tiny little shop out a two lane highway, in the middle of nowhere, who thinks because a piece sold on eBay for some crazy amount, they should get that price too. When I ask them if they will take less, sometimes they will say, "That's what it goes for on ebay." I always remind them we are in Georgia and if they want to sell it at Yankee prices, they should list it on ebay and let somebody in New York buy it. Of course, I say it in a very polite, I'm just trying to help you out, kind of way. Ha!
Reply With Quote
Old 12-19-2017, 04:52 PM
Christian James Christian James is offline
Join Date: Jan 2017
Posts: 61
Default Re: Iron Pricing

I've only been into vintage CI for a year, so I know I've overpaid for my pieces. This is what I've spent.

$35 - Griswold no. 8 SBL grooved handle
$100 - Griswold no. 6 SBL early handle, Griswold no. 7 early handle, Griswold no. 8 SBL late handle
$18 - Griswold no. 3 LBL smooth bottom
$25 - Griswold no. 5 SBL grooved handle
$40 - Griswold no. 8 Slant EPU
$22 - fully marked Wagner/National no. 9 w/ heat ring
$20 - unmarked Wanger no. 8

At a grand total of $260, I've shelled out an average of $28.89 per pan. Not even close to the bargain prices I've read about, but not that far off from the cost of a modern Lodge. And way cheaper than the new artisanal pans from the likes of Smithey and Butter Pat. Given the local market I'm in (SF Bay Area) and my relative lack of effort, I don't think I've taken too bad a beating. I look at it as paying a slight premium for convenience.

Ultimately it comes down to how bad you want a pan and how much you are willing to spend.
Reply With Quote
Old 12-19-2017, 05:58 PM
Hrodebert S Hrodebert S is offline
Join Date: Jul 2017
Location: S.W. Michigan
Posts: 26
Default Re: Iron Pricing

Originally Posted by Christian James View Post
Ultimately it comes down to how bad you want a pan and how much you are willing to spend.
This pretty much sums it up for me.
I also have not been collecting long, or as enthusiastically as most on here, but I will say that the only regrets I have so far are not paying the price on a couple of things I have wanted.
I have no regrets about any of the purchases I have made so far, and I think my average for pieces is a bit lower than yours.
Reply With Quote
Old 12-19-2017, 10:20 PM
D_Madden D_Madden is offline
Senior Member
Join Date: Dec 2016
Location: Southern Indiana
Posts: 941
Default Re: Iron Pricing

just as a follow up... finished up the #5 and took a 'family photo' for the holidays. All 4 of these are amazingly clean and smooth.

side note: the 3 is the only one with " ERIE "... the others are just plain ERIE... and the 4 and 5 have the size on top of the handle and the 3 and 8 don't.
Reply With Quote
Old 12-19-2017, 11:37 PM
SShort SShort is offline
Senior Member
Join Date: Oct 2017
Location: East Texas
Posts: 148
Default Re: Iron Pricing

I ran into a dealer the other day that says he figures out what the price is for a particular item on eBay and then he divided by two and sells it for that price. He realizes eBay prices are usually higher than most people that collect are willing to pay. There is a dealer at a flea market here in East Texas which happens to be the largest flea market in the United States. He has well over 6000 pieces of cast-iron at any particular time for sale. But he is always extremely high. I always seem to find better pieces and better prices at fleamarketís other than the one I just mentioned then I do at antique stores.
Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


- Website Directory -

This site is a participant in the Amazon Services LLC Associates Program,
an affiliate advertising program designed to provide a means for sites to earn
advertising fees by advertising and linking to or its affiliates.
This page contains ads and links that earn commissions for CIC.

All times are GMT -5. The time now is 10:35 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.