Thread: Lamb Mold
View Single Post
Old 12-10-2017, 01:10 PM
CJ Lucas CJ Lucas is offline
Senior Member
Join Date: Jan 2016
Posts: 125
Default Re: Lamb Mold

The lamb mold I have is a No. 866 and the front half is larger than the back half. It has the vent holes in the back. You are supposed to place the mold "face-side" down, fill with batter and place the "back-side" on top. With the mold placed face-down, the batter will properly fill the face and you will get the definition you are looking for.

Perhaps someone that didn't know how to use the mold drilled vent holes in the front. Not sure if yours is a knock-off.

[SIZE=1]---------- Post added at 01:10 PM ---------- Previous post was at 12:36 PM ----------[/SIZE]

I also have one that has the back-half larger than the front and it has no vent holes or markings of any kind that I can find. It is 13 3/8 x 8
Reply With Quote