Cast Iron Collector Forums

Cast Iron Collector Forums (http://www.castironcollector.com/forum/index.php)
-   Cast Iron Cleaning and Seasoning (http://www.castironcollector.com/forum/forumdisplay.php?f=7)
-   -   Removing “Exfoliated”, Hard Rust Buildup (http://www.castironcollector.com/forum/showthread.php?t=8051)

WillB 08-09-2020 10:27 AM

Removing “Exfoliated”, Hard Rust Buildup
 
Hi,

I’ve been trying to clean off the rust buildup on the bottom of a Dixie Foundry #8. I started the piece off with easy off which removed some of the carbon/seasoning buildup. Then I put it in an E tank which removed the rest of the seasoning. It doesn’t seem to have touched the rust buildup on the bottom though. This is hard rust/iron which will chip off if hit hard enough with a flat head screwdriver. It’s also hard to tell which is the “exfoliated” rust and which is the pitted bare iron. Any suggestions?

https://imgur.com/a/Rmzxij4

Jay Reiter 08-09-2020 09:15 PM

Re: Removing “Exfoliated”, Hard Rust Buildup
 
Something like that takes a wile in the e tank. What voltage and current are you indicating? I would say keep going and scrub the pot with a wire brush in the evening. The rust will come off little by little. I had problems like that and it took several days to a week. They were not that rusted.

Doug D. 08-09-2020 10:15 PM

Re: Removing “Exfoliated”, Hard Rust Buildup
 
This is some major sulfur putting. Metal has been dissolved and reformed by the sulfuric acid created by use over a sulfur containing heating fuel. It's not going to come off and reveal anything underneath. Electro should remove whatever rust is present among the pits, but that's about it. I wouldn't expect chiseling at it to result in anything positive. It can still be an acceptable user, just a rather homely one.

WillB 08-09-2020 11:29 PM

Re: Removing “Exfoliated”, Hard Rust Buildup
 
Not sure on the amperage. I have about 12 volts differential however (using a boat battery with an automatic charger).

I wasn’t planning on chipping at it anymore. That was just see how well the rust was adhered.

I’ll put it back in the e-tank and make sure my anodes are cleaned and closer to the piece than they were before.

BryanB 08-10-2020 04:33 PM

Re: Removing “Exfoliated”, Hard Rust Buildup
 
How slick is the inside? Don't want pits meeting in the middle.

WillB 08-10-2020 05:12 PM

Re: Removing “Exfoliated”, Hard Rust Buildup
 
That has crossed my mind... The inside has a slight low spot (warped) but it’s very smooth.


All times are GMT -5. The time now is 11:17 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.